Pro AV Catalog
Manufacturers
PRODUCT CATEGORIES
Matching Keywords
Model Numbers
Request Quote
All Products
Shortwave Magnetic Loop Antenna
Model: RF PRO-1B
- Very low IMD, 30 dB Low-Noise Preamp insures good performance in both strong and weak signal environments
- Up to 30 dB rejection of locally radiated noise compared to whip antennas
- Figure eight directivity and deep nulls to further reduce interference
- Primary coverage range: 100 kHz to 30 MHz
- Rejects power line noise
Product Info
Tech Specs
Documents
This shortwave magnetic loop antenna For improved reception and noise rejection. The shielded active broadband magnetic loop architecture provides enhanced noise rejection over standard antennas.This active magnetic loop antenna is designed for reception of signals over the range of 50 kHz to 30 MHz. It includes a very high dynamic range low-noise preamplifier that can be mounted to a pole or any flat surface. The preamplifier is designed for minimum intermodulation distortion in the presence of very high level signals that would normally overload most amplifiers. For proper operation the preamplifier needs to be powered as shown in the diagram shown in Figure 1 with the supplied power inserter and power supply that duplexes DC power on the same cable carrying the preamplifier’s output. The antenna should be oriented in the proper direction to maximize reception
of the desired signals (see details below). For best performance, the amplifier should be installed near the antenna to avoid amplifying low level local interference that may enter the coaxial cable leading from the loop antenna to the
preamplifier’s input.
- Very low IMD, 30 dB Low-Noise Preamp insures good performance in both strong and weak signal environments
- Up to 30 dB rejection of locally radiated noise compared to whip antennas
- Figure eight directivity and deep nulls to further reduce interference
- Primary coverage range: 100 kHz to 30 MHz
- Rejects power line noise
- Rugged construction, easily mounts to a pole or flat vertical surface, 1m dia. aluminum loop, supplied with LNA, power inserter and DC power supply
- No manual tuning necessary
- No Home Owners Association problems; low profile, easy to camouflage and works at ground level
- Modular design for easy installation and maintenance
- Adjustable output level to optimize output for your radio
- Internal Transmit / Receive Switch disconnects Antenna / Preamp from your receiver when transmitting
- Antenna Directivity - Omnidirectional
- Diameter: 38 in
- Frequency Response: 50 kHz to 30 MHz (Gain: 30 dB ±3 dB)
- DC Power: 20 volts at 270 mA
- LNA OIP3: +48 dBm
- LNA OIP2: > +100 dBm (typically 110 dBm)
- 1dB compression point: +27 dBm
- NF: < 2 dB (at 10 MHz)
- Antenna Diameter: 38 inches
- Maximum cable length between antenna and power inserter: 1000 ft
Loop Antenna
219 kb
- Brochure
Request Quote
Suggested Products
Thank you!
Someone will be in touch with you shortly.
Contact Lowrance Sound Company, Inc.
close
Lowrance Sound Company, Inc.
2132 Nailing Drive
Union City, TN 38261
USA
(901) 885-4504
www.lowrancesoundcompany.com
Contact in regards to this product:
Pixel Technologies Inc.
Model: RF PRO-1B
Request more information from a dealer near you
close
Request more information from a dealer near you